简体中文 
We are serious about deburring
We are serious about chamfering and deburring
Wuxi HOPE technology focuses on orifice deburring and chamfering solutions. We not only provide high-quality deburring tools, but also provide optimized solutions.
The standard SAVANTEC brand deburring and chamfering cutter can only have its limitations. For many through holes and special-shaped holes, the standard products can not meet the needs of customers. At this time, our technical team can design non-standard cutter rods and non-standard blades according to the actual working conditions of customers, so as to meet the needs of customers for deburring various through holes and special-shaped holes.
The deburring tool for the front and back holes of SV-BW has requirements for the aperture ratio, and the maximum aperture ratio (d: D) is about 0.5. The angle corresponding to the inclined plane where the base hole is located is within 18 °. If the aperture ratio (d: D) of the base hole and the main hole is greater than 0.5, it means that the inclination is greater than 18 °. We can only modify the main deflection angle and rear angle of the blade to achieve (we need to test whether it can meet the customer's requirements). The formula to verify whether the standard blade is suitable: d: D ≤ 0.5 When machining through perforation as shown in the figure, the spindle speed needs to be reduced and the feed remains unchanged. |  |
